Carbon Steel Sheet A1011,30 L,12 W

6 in, Actual Width 0.

O-Ring, Metal Detectable Metal Detectable, Not X-Ray Detectable X-Ray Detectable, System of Measurement Inch, Cross Section Shape Round, O-Ring Material Viton, Durometer (Hardness) Rating Medium Hard, Nominal Inside Dia.5/8 in, Nominal Width 3/16 in, Actual Inside Dia. Range -15 Degrees to 400 Degrees F, FDA Approved FDA Approved 1.

5 mm, Dash Number Not Applicable, Color Red, Durometer 70A, Meets/Exceeds FDA, Nominal Outside Dia. Silicone O-Ring, 2.5mm Wide 15mm ID, PK25.

068 in, Temp.

25 in, Abrasion Resistance Good.Rubber Strip, Strip, Adhesive Type Acrylic, Backing Type Adhesive, Color Black, Durometer 30A, Grade Standard, Material Neoprene, Standards ASTM D2000 BC 310, Maximum Adhesive Temperature 230 Degrees F, Maximum Temperature 250 Degrees F, Minimum Adhesive Temperature -30 Degrees F, Minimum Temperature -30 Degrees F, Overall Length 36 in, Thickness Tolerance +/-0.

Polyurethane Sheet, Material Polyurethane, Shape Sheet, Grade Standard, Length 6 ft, Width 24 in, Thickness 1/2 in, Backing Type Plain, Cell Type Open Cell, Adhesive Type Plain Backing, Number of Adhesive Sides 0, Color Gray, Density 2 lb/cu ft, Maximum Temperature 160 Degrees F, Minimum Temperature -20 Degrees F, Tensile Strength 20 psi, Texture Smooth, Firmness @ 25 Percent Deflection 6 psi, Material Skin None, Flexibility Good, Standards CAL 117, Chemical Resistance Fair, Oil Resistance Fair.

12, Water Absorption 0.01 Percent, Temperature Range -22 Degrees to 180 Degrees F, Plastic Hardness 66D.

125/+0.000 in, Yield Strength 36,000 psi, Fabrication Hot Rolled, Machinability Not Rated, Rockwell Hardness B75, Tensile Strength 58,000 psi, Length Tolerance -0.A1011 Carbon Steel Sheet, Material Carbon Steel, Material Grade A1011, Heat Treatable No, Heat Treatment Annealed, Mechanical Finish Mill, Overall Length 30 in, Overall Width 12 in, Thickness 0.

Sheet Stock, UHMW Polyethylene, Grade Antistatic, Plastic Length 24 in, Plastic Width 24 in, Plastic Thickness 0.01 Percent, Temperature Range -22 Degrees to 180 Degrees F, Plastic Hardness 66D.

135 in, Thickness Tolerance -0.