18 Carbide Tipped Stub Length Drill

HSSE-V3% Vanadium - Superior performance in stainless steels - Up to 35 HRC.

Drill Bit Size Inch 716 Shank Taper Designation MT1 Drill Point Angle Degrees 118 Drill Bit Material Carbide Tipped Drill Bit FinishCoating Bright Overall Length Inch 714 Through Coolant No Provides excellent wear resistance when cutting aluminum castings, bronze, cast and ductile irons, fiberglass, hard plastics and other nonferrous materials NOT recommended for steel applications 118Deg point.

- Steel sealed for coolant through applications - Pressure resistance tested to 2000 psi.

Series Name 2 Diameter mm 33 Diameter Decimal Inch 12992 Series CodeSeat Size 2 Material Cobalt Coating TiAlN Thickness Inch 316 Included Angle 132 For drilling in High Alloy materials exotic materials, T15 may also be used in general purpose applications where increased speeds and enhanced wear resistance is required 132Deg point.

Drill Bit Size Wire 48 Drill Point Angle Degrees 118 Drill Bit Material High Speed Steel Drill Bit FinishCoating Black Oxide Flute Type Spiral Cutting Direction Right Shank Type Straight Coolant Through No These drills are designed primarily for drilling in nonferrous materials such as Aluminum, Zinc die cast, and some plastics They are successfully used in mild steel deep holes where chip packing occurs with standard helix drills Bright finish 118Deg points High Speed Steel.

Cutter Diameter Inch 9 Cutting Width Inch 34 Tooth Configuration Staggered Material High Speed Steel FinishCoating Uncoated Arbor Hole Diameter Inch 112 Number of Teeth 30.

Drill Bit Size Inch 18 Drill Point Angle Degrees 118 Drill Bit Material Carbide Tipped Drill Bit FinishCoating Bright Flute Type Spiral Flute Cutting Direction Right Hand Shank Type Straight Coolant Through No Provides excellent wear resistance when cutting aluminum castings, bronze, cast and ductile irons, fiberglass, hard plastics and other nonferrous materials NOT recommended for steel applications 118Deg point.

.Typhoon ball nose end mills are designed for long reach contour milling applications in hardened materials.

Drill Bit Size Inch 18 Drill Point Angle Degrees 118 Drill Bit Material Carbide Tipped Drill Bit FinishCoating Bright Flute Type Spiral Flute Cutting Direction Right Hand Shank Type Straight Coolant Through No Provides excellent wear resistance when cutting aluminum castings, bronze, cast and ductile irons, fiberglass, hard plastics and other nonferrous materials NOT recommended for steel applications 118Deg point.

Typhoon ball nose end mills are designed for long reach contour milling applications in hardened materials..