GS536X60 CAT50 Retention Knob 1-8 Drawbar Thread

CONTINENTAL ABRASIVES FC-4551207 4-1/2" x 7/8" 120 Grit T27 Ceramic Standard.

Circlip Pliers Angled External 45 deg., Sise 40mm-100mm, Tip 2.3mm with 66 Finish Black Dipped Handle•For fitting external circlips on shafts•With 45° angled jaws•Anti-slip, twisted precision tips•With opening spring•Handles coated with plastic•Made of chrome vanadium steel, forged, oil-hardened.

Shank Type Taper Shank Taper Size CAT40 Hole Diameter Inch 38 Projection Decimal Inch 315 Nose Diameter Decimal Inch 094 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

Shank Type Taper Shank Taper Size NMTB40 Hole Diameter Inch 34 Nose Diameter Decimal Inch 189 Projection Decimal Inch 231 Through Coolant No All ground body.

Collet System ER Collet Series ER25 Shank Type Taper Shank Taper Size CAT50 Projection Decimal Inch 6 DIN Coolant option standard All Ground Body Factory Balanced to save spindle life, tool life and increased productivity Threaded through holes for a backup screw tool stop or coolant through when removed Wrench not included Premium balanced to G25 At 30,000 rpm.

GS TOOLING 382473 Chrome Locking Ball For Blocking Device.

GS536X60 CAT50 Retention Knob 1"-8 Drawbar Thread Please have ready the following information when calling: - Taper of machine - Make & Model of the machine - Draw Bar thread diameter and pitch - Taper Angle required underneath head of stud - Optionally: Solid or Coolant Thru Can't find your pull stud?.

Type Outside Caliper Joint Type Quick Nut Maximum Measurement Inch 4 Spring joint for precision settings Legs pivot on a roller Legs tensioned by bow spring.

GS536X60 CAT50 Retention Knob 1"-8 Drawbar Thread Please have ready the following information when calling: - Taper of machine - Make & Model of the machine - Draw Bar thread diameter and pitch - Taper Angle required underneath head of stud - Optionally: Solid or Coolant Thru Can't find your pull stud?.

Type Outside Caliper Joint Type Quick Nut Maximum Measurement Inch 4 Spring joint for precision settings Legs pivot on a roller Legs tensioned by bow spring.