10.5mm ER20 Sealed Collets

14".

SURE-LOC HARDWARE BL-TB30 FBL Sure-Loc Hardware Boulder 30 Towel Bar, Flat Black.

2054X SizeM12.

Shank Type Taper Shank Taper Size CAT40 Hole Diameter mm 10 Projection mm 80 Nose Diameter mm 24 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

D.GS 1" O..

Shank Type Taper Shank Taper Size NMTB40 Hole Diameter Inch 78 Nose Diameter Decimal Inch 201 Projection Decimal Inch 294 Through Coolant No All ground body.

- Steel sealed for coolant through applications - Pressure resistance tested to 2000 psi.

Style Equal Double Threaded System of Measurement Inch Thread Size Inch 5811 Overall Length Inch 14 Material Medium Carbon Steel FinishCoating Black Oxide Black Oxide finish Medium carbon steel Most studs have wrench flats Special lengths and sizes will be quoted on request.

- Steel sealed for coolant through applications - Pressure resistance tested to 2000 psi.

Style Equal Double Threaded System of Measurement Inch Thread Size Inch 5811 Overall Length Inch 14 Material Medium Carbon Steel FinishCoating Black Oxide Black Oxide finish Medium carbon steel Most studs have wrench flats Special lengths and sizes will be quoted on request.