4-Beam Clamp Coupling, Bores 11mmx0.375, OD 1.181, Stainless Steel
About The 9 standards for maximum torque capabilities. This MW-series beam coupling is machined from a single piece of stainless steel and features two sets of two spiral cuts allowing for higher torque capacity and lower windup than single beam couplings.0mm) OD, and 1. This coupling is best suited for encoders
Stainless steel is used for higher torque capabilities than aluminum versions, however the coupling will have significantly higher inertia. It has pure metric outer diameter and length dimensions to fit in a smaller envelope than Ruland P-series beam couplings for easier interchanges with single beam couplings. Ruland four beam couplings are zero-backlash and have a balanced design for reduced vibration at high speeds up to 6,000 RPM. This coupling is best suited for encoders. This coupling is clamp style and has 11mm x 0.375" bores, 1.181" (30.0mm) OD, and 1.496" (38.0mm) length. Hardware is metric and tests beyond DIN 912 12.9 standards for maximum torque capabilities. This MW-series beam coupling is machined from a single piece of stainless steel and features two sets of two spiral cuts allowing for higher torque capacity and lower windup than single beam couplings. It is RoHS and REACH compliant.
Bearings,V-belts & Power Transmission Equipment,Couplings,Collars,& Adapters,Motion Control Couplings
4-Beam Clamp Coupling, Bores 11mmx0.375, OD 1.181, Stainless Steel
Bearings,V-belts & Power Transmission Equipment,Couplings,Collars,& Adapters,Motion Control Couplings
Specifications of 4-Beam Clamp Coupling, Bores 11mmx0.375, OD 1.181, Stainless Steel | |
|---|---|
| Category | |
| Instock | instock |
