JW Winco GN632.1-5/16X18-63 Grub Screw

A-Section Belt Package, Dim A (1): A Classical V-Belts, Dim B (2): Qty 43, Dim C (3): A18 thru A60.

Hex Shank Drill Bit, 5/16 in, Drill Bit Point Angle 118 Degrees , Drill Bit Point Type Split Point, Cobalt, Straw/Bronze.

Leather Gloves, Hand Protection Style Glove, Additional Hazard Protection None, ANSI/ISEA Heat Level Not Available, Leather Glove Style Work, ANSI/ISEA Impact Level Not Tested, Finger Coverage Full Finger, Insulated Yes, Leather Coverage Style Leather Palm, Glove Length 10 1/2 in, Glove Hand Style Left and Right, Thumb Style Wing, Glove Insulation Material Thinsulate(TM), Cuff Style Safety, Glove Liner Material Thinsulate(TM), Leather Grade Premium, Oil-Resistant No.

Tortilla Shell Pan, Gauge 22 ga, Material Aluminized Steel, Dishwasher Safe No, Freezer Safe No, Oven Safe Yes, Overall Width 6 5/8 in, Overall Depth 2 1/4 in, NSF Certified No, Pan Style Tortilla Shell Pan.

All components and valving are specifically designed and calibrated to match form, fit and function for vehicle application and provide the OE ride and feel. All components are new and made to O.E.

Liquid Lines attach condenser to evaporator.Hose Discharge Line,4812535 Discharge (high side) attach from compressor to condenser..

GN817-6-6-1/2X13-G Indexing Plunger This indexing plunger has the unique feature of the pull knob partially enclosing the top of the plunger body, allowing less debris to enter into the mechanism. GN 817 indexing plungers with lock-out (Type C / CK) are used for applications where the plunger pin needs to stay in its retracted position.

1 grub screws are typically used with thrust pads, making a low-cost solution for clamping operations or for load bearing purposes.GN 632.

GN817-6-6-1/2X13-G Indexing Plunger This indexing plunger has the unique feature of the pull knob partially enclosing the top of the plunger body, allowing less debris to enter into the mechanism. GN 817 indexing plungers with lock-out (Type C / CK) are used for applications where the plunger pin needs to stay in its retracted position.

GN 632..