Solid Carbide Drill With 180 Deg Point Angle, Plain Shank, TiAlN Coated, 11.8 Mm
About The . With 4 guide chamfers to stabilize the drill in the hole. Flute geometry for optimum chip evacuation. Recommendation: When using the solid carbide 180 Deg drill it is absolutely essential for process reliability: When spot drilling on flat surfaces to drill a pilot hole 1xD using pilot drill No
Low radial forces even when spot drilling on faces with up to 15 Deg slope. Special point geometry for generating 180 Deg flat-bottomed holes. Advantage: The 180 Deg point angle permits drilling and counterboring in a single operation. After spot drilling, the normal feed rate value can be used. Note: Flute length LC = L2 + 1.5 x DC. Flute geometry for optimum chip evacuation. When spot drilling on sloping surfaces up to max. 122736. 15 Deg reduce the feed rate f to 25% of the stated value. Recommendation: When using the solid carbide 180 Deg drill it is absolutely essential for process reliability: When spot drilling on flat surfaces to drill a pilot hole 1xD using pilot drill No. With 4 guide chamfers to stabilize the drill in the hole.
Cutting Tools,Drill Bits,Jobber Length Drill Bits
Solid Carbide Drill With 180 Deg Point Angle, Plain Shank, TiAlN Coated, 11.8 Mm
Cutting Tools,Drill Bits,Jobber Length Drill Bits
Specifications of Solid Carbide Drill With 180 Deg Point Angle, Plain Shank, TiAlN Coated, 11.8 Mm | |
|---|---|
| Category | |
| Instock | instock |
