M3M5 ER32 Tap Collet 35x27

235.

Shank Type Taper Shank Taper Size HSK63A Hole Diameter Inch 114 Projection Decimal Inch 630 Nose Diameter Decimal Inch 173 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

Shank Type Taper Shank Taper Size MT3 Projection Decimal Inch 587 Tapping Style TensionCompression.

Tool Post Holder Number 1 Tool Post Holder Type Turning Facing Holder Lathe Swing Inch 1318 Overall Height Inch 218 Takes various sizes of bits Turning and facing tools can be locked in together Saves time and labor when changing operations.

Tool Post Holder Number 1 Tool Post Holder Type Turning Facing Holder Lathe Swing Inch 1318 Overall Height Inch 218 Takes various sizes of bits Turning and facing tools can be locked in together Saves time and labor when changing operations.