#10-24 UNC HSS Left Spiral Point 2 Flute Tap

High Speed Steel Hand Taps are used to make new threads or re-thread damaged and or jammed threads.

Short, rugged construction performs well in a broad range of materials. Left hand jobber drill bits are for general purpose construction. Sizes smaller than 1/16 and #52 have the 118 degree standard point.

Cobalt drill bits are are effective in drilling tough, high tensile strength materials such as cast iron, inconel, stainless steel and titanium.#60 Cobalt Jobber Length Drill Bit, D/ACO Series They have a 135° split point tip for fast penetration and accurate drilling..

#38 Cobalt Jobber Length Drill Bit The 135 split point is self-centering and reduces thrust. Sizes smaller than 1/16” or #52, and larger than 1/2” have the 118° standard point. Cobalt jobber drills. These drill bits display high red hardness, permitting speeds up to 30% greater than with conventional M2 high speed steel, and are especially effective in drilling tough, high tensile strength materials like stainless steel, inconel, and titanium.

3/16" Tin Coated Jobber Length Drill Bit Tin coated jobber drills have super hard titanium nitride surface treatment improves drill life, chip ejection, and productivity; decreases horsepower requirements..

. Do not use with a standard hand drill or drill press Comes with pilot pin. nACo Nano-Composite Blue coating increases tool life up to 30% compared to traditional HSS annular cutters Cuts difficult materials, including steel, cast iron, heated and stainless steels.

Contractor grade drill bit manufactured from M1 High Speed Steel and for use in a wide range of materials in the iron and steel families such aluminum, iron, steel and other metal drilling. Compared to a conventional 118 degree tip, these drills wont go "walking" on you.

. Spiral-Pointed taps, or Machine Taps, were originated to solve the problem of tap breakage in through hole tapping.#10-24 UNC HSS Left Spiral Point 2 Flute Tap Ideal for threading a wide variety of ductile materials, copper and copper alloys, brass and non-metallics.

1-27/64" HSS Black & Gold Drill Bit with Reduced 1/2" 3-Flat Shank, Contractor Series. 3-Flat shank for an extra secure hold in your chuck.

#10-24 UNC HSS Left Spiral Point 2 Flute Tap Ideal for threading a wide variety of ductile materials, copper and copper alloys, brass and non-metallics.