BT40 78 X 338 End Mill Holder

TOMPKINS FF6840-12-12 Hydraulic Fitting-Flange12MORFS-12FL C61.

TOMPKINS FF6809-20-20 Hydraulic Fitting-Steel20MOR-20FORFSX 90.

TOMPKINS FF6803-08-06-08 Hydraulic Fitting-Steel08MORFS-06MORFS-08MOR TEE.

TOMPKINS FF2603-06-06-06 Hydraulic Fitting-Steel06MORFS-06MORFS-06MORFS TEE.

SUBURBAN BOLT AND SUPPLY A0430480008H Hex Nut, 3/4"-16, Grade 8, Plain.

Shank Type Taper Shank Taper Size HSK63A Hole Diameter mm 10 Projection mm 85 Nose Diameter mm 24 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

Shank Type Taper Shank Taper Size BT40 Hole Diameter Inch 78 Nose Diameter Decimal Inch 2 Projection Decimal Inch 338 Through Coolant Yes DIN Coolant option standard All Ground Body Premium balanced to 30,000 rpm Comes with certificate.

Shank Type Taper Shank Taper Size CAT40 Hole Diameter Inch 316 Nose Diameter Decimal Inch 075 Projection Decimal Inch 25 Through Coolant Yes DIN Coolant option standard All Ground Body Premium balanced to 30,000 rpm Comes with certificate.

Shank Type Taper Shank Taper Size BT40 Hole Diameter Inch 78 Nose Diameter Decimal Inch 2 Projection Decimal Inch 338 Through Coolant Yes DIN Coolant option standard All Ground Body Premium balanced to 30,000 rpm Comes with certificate.

Shank Type Taper Shank Taper Size CAT40 Hole Diameter Inch 316 Nose Diameter Decimal Inch 075 Projection Decimal Inch 25 Through Coolant Yes DIN Coolant option standard All Ground Body Premium balanced to 30,000 rpm Comes with certificate.