Triangle Turning Insert, Triangle, 5/8 In, TBGD, 0.0156 In, PCD

Rotary Shaft Seal, Design Code TC, Inside Diameter 25 mm, Outside Diameter 48 mm, Overall Width 8 mm, Contact Type Contact Seal, Lip Material Nitrile Rubber, Maximum Pressure 7 psi, Number of Lips 2, System of Measurement Metric, Case Coating None.

Rotary Shaft Seal, Design Code SCV, Inside Diameter 25 mm, Outside Diameter 40 mm, Overall Width 7 mm, Contact Type Contact Seal, Lip Material Fluoro Rubber, Maximum Pressure 10 psi, Number of Lips 1, System of Measurement Metric, Case Coating None, Maximum Surface Speed 999 mps, Seal Type Single Lip Seal.

Rotary Shaft Seal, Design Code SCV, Inside Diameter 6 mm, Outside Diameter 15 mm, Overall Width 4 mm, Contact Type Contact Seal, Lip Material Fluoro Rubber, Maximum Pressure 10 psi, Number of Lips 1, System of Measurement Metric, Case Coating None, Maximum Surface Speed 999 mps, Seal Type Lip Seal.

Manual Two-Way Ball Valve, Body Material Stainless Steel, For Media Combustible Gases, Valve Construction One-Piece, Nominal Valve Size 1/4 in, Valve Body Style Straight, 3-A Standard Compliance Not Rated, Average Surface Roughness (Ra) Not Applicable, Maximum Pressure - Operating 2,160 psi, Maximum Pressure - Steam 200 psi, Maximum Pressure - Combustible Gas Not Rated, Vacuum Service Rating -29.912 in Hg, Ball Material 316 Stainless Steel, Ball Port Style Full Port, Handle - Locking Locking.

Cone Bearing Heater, Heater Type Cone, Portability Non-Portable, For Maximum Bore Diameter 8 1/4 in, For Minimum Bore Diameter 3/8 in, Maximum Output Temperature 250 Degrees F, Operating Voltage 120V, Current 15 A, Power Consumption 1,800 W, Overall Depth 8 11/16 in, Overall Height 9 1/2 in, Overall Width 8 11/16 in, Display Type None, Features Far Safer than Heating Bearings with Oil Baths or Hotplate, Great Alternative to Larger Units at a Much Lower Cost Point.

Diamond Turning Insert, Inscribed Circle 3/8 in, ANSI Code NF-VNMX331, Chip-Breaker Style 10 Degrees Rake Angle, Clearance Angle 0 Degrees.

Triangle Turning Insert, Inscribed Circle 5/8 in.

Square Turning Insert, Inscribed Circle 3/8 in, Absotech Platinum.

Triangle Turning Insert, Inscribed Circle 5/8 in.

Square Turning Insert, Inscribed Circle 3/8 in, Absotech Platinum.