GS444X60 BT40 Retention Knob With M16x2 Drawbar Thread

TOMPKINS SS-FF0319-08-FG Hydraulic Fitting-Stainless08 BRAZE-ON SLEEVE-SS.

STAHLWILLE TOOLS 41080911 Double ended open ring Wrench OPEN-RING Size 9 x 11.

Shank Type Taper Shank Taper Size BT40 Hole Diameter Inch 38 Projection Decimal Inch 354 Nose Diameter Decimal Inch 094 Through Coolant Yes Unsurpassed Accuracy Concentricity of Less than or equal too00001 3 Micron with tool shrunk in holder Coolant Ports Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool Max Gripping Torque Tool is gripped 360Deg along the entire length of bore producing very high gripping torque, preventing chatter Increased Production Decrease down time the total time elapsed to remove one cutting tool and insert another is less than 10 seconds Balanced GS follows the strictest balance standards Our holders are prebalanced G25 up to 30,000rpm Extended Holder Life With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder Chip load distributed evenly along cutting edge of tool which results in longer tool life Short projections are possible because no mechanical clamping devices are used This results in greater rigidity and resistance to bending Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

Taper Size HSK100A Shank Type Taper Shank Hole Diameter mm 32 Nose Diameter Decimal Inch 2717 Projection Decimal Inch 5315 HSK Advantages High rigidity and torque transmission almost double the rigidity of Vflange holders Extreme concentricity enhance tool life performance Coolant thru capabilities.

Collet System ER Collet Series ER25 Shank Type Taper Shank Taper Size BT30 Projection Decimal Inch 2 DIN Coolant option standard All Ground Body Factory Balanced to save spindle life, tool life and increased productivity Threaded through holes for a backup screw tool stop or coolant through when removed Wrench not included BT30BT40 Premium balanced to 30,000 rpm BT50 Premium balanced to 25,000 rpm.

Collet System ER Collet Series ER20 Shank Type Taper Shank Taper Size CAT40 Projection Decimal Inch 9 DIN Coolant option standard All Ground Body Factory Balanced to save spindle life, tool life and increased productivity Threaded through holes for a backup screw tool stop or coolant through when removed Wrench not included Premium balanced to G25 At 30,000 rpm.

GS TOOLING 382870 Jaw Plate For Fixed Jaws For 5 Modular Vises.

GS444X60 BT40 Retention Knob With M16x2 Drawbar Thread Please have ready the following information when calling: - Taper of machine - Make & Model of the machine - Draw Bar thread diameter and pitch - Taper Angle required underneath head of stud - Optionally: Solid or Coolant Thru Can't find your pull stud?.

GS TOOLING 382870 Jaw Plate For Fixed Jaws For 5 Modular Vises.

GS444X60 BT40 Retention Knob With M16x2 Drawbar Thread Please have ready the following information when calling: - Taper of machine - Make & Model of the machine - Draw Bar thread diameter and pitch - Taper Angle required underneath head of stud - Optionally: Solid or Coolant Thru Can't find your pull stud?.